Question No : 1
From the NSX Edge CLI, which command would show VIP statistics?
A. show service loadbalancer pool
B. show service loadbalancer virtual
C. show service loadbalancer monitor
D. show service loadbalancer
Answer: B
Explanation:
https://kb.vmware.com/selfservice/microsites/search.do?language=en_US&cmd=displayKC &externalId=2122708
QUESTON NO: 99
Your environment has two sites designated as Site A and Site B. Each site has its own vCenler Server instance with NSX installed and configured in standalone mode You are migrating the environment to Cross vCenter and have already promoted Site A to the Primary role.
What action must be taken before the NSX Manager at Site B can be changed to Secondary?
A. Migrate the Site B Controllers to Site A
B. Convert the Site B Controllers to Universal Controllers
C. Remove any logical switches from the Site B NSX Controller.
D. Delete the Controllers at Site B
Answer: B
Question No : 2
A new ESXi host was added to an existing cluster, prepared for NSX and enabled for Distributed Firewall, logical switching and Logical Routing.
The Most Preparation page in the NSX Web Ul shows this new host is in Ready state and the Logical Network Preparation tab displays the VXLAN VTEPs are correctly configured.
Virtual machines on the new host can communicate with each other but CANNOT communicate with VMs running on other hosts and connected to the same Logical Switch.
Which condition below will result in the described behavior on the new host?
A. NSX Edge is powered off
B. Host Agent (vpxa) to vCenter is disconnected
C. Rabbitmq message bus connection (vsfwd) to NSX Manager is down
D. Network Control Plane Agent (netcpa) connection to the controller is down
Answer: B
Question No : 3
Which tool is used to display VXLAN connection information?
A. pktcap-uw
B. NSX Controller CLI
C. esxtop
D. VDS Health Check
Answer: B